100% Output Li-ion Battery Emergency Light Conversion Kit
This NA02-F60 Is New Model Intergrated Led Emergency Modules can be controlled by switch on/off when power cut. This conversion kit can connect several LED bulbs, LED lamps, LED tubes or downlights in emergency for operating total not over 60W in 100% power output. The Full Power Emergency Battery Pack is suitable for converting existing light fittings to emergency operation. You no need to change the wiring. And 100% to save your electric power cost.
•Switch On/Off Emergency Mode
•DC Output: 220V
•Emergency time more than 3 hours
•Battery: 11.1V lithium ion 4400mAh
•Material: PC+ABS
•Deep discharge protection, IC control Prevent overcharging and over discharging
Intergrade design. Easy install and maintain
Size
In contrast to LED drivers, the Emergency Driver For Panel is used to transform a regular panel light into an un-maintained emergency light. The power source for an LED panel is monitored and controlled by an LED emergency driver.
This driver powers the LED from the mains when the power is on and continues to recharge the battery that is built into it.
In the event that the primary sources fail for whatever reason, the LED emergency driver instantly switches the power supply to the battery and prevents the light from turning off.
Main Specification
Model: NA02-F60 |
Input Voltage | 85-265V 50/60HZ | Battery Type | 11.1V 4400mAh |
Match Light Source | 3-60W LED LAMP | Dimension | 28*6.1*3.5CM |
Emergency Output Power | 3-60W | Protection Grade | IP20 |
Emergency Conversion Time | <5S | Charging time | 24hours |
Working Temperature | -10~50°C | Emergency time | 120mins |
Material | ABS | Warranty | 3 years |
Wiring Diagram
FAQ:
1. Can I turn off the lights on this driver if I do not need the emergency lighting function?
Yes, you can turn on and off for your need.
2. What is the large emergency time for this Led Pendant Light Conversion Kit?
If the connect led lamp is 60W, the emergency time is 60mins, if connect the 20W, emergency time is 180mins.
3. How to wire this conversion kit to the led lamp?
Make sure you will wire the led lamp according to our surface drawing of the led driver. And you can read carefully the instruction sheet before you wire it.
4. What if it is more than one lamp when I use the emergency model?
Good question. The answer is Yes for this model. But it should be under below request: all of the wattage for the lamps muse less than the LED driver’s power support.